G92 - Set Position


Set the current position to the values specified. In Marlin 1.1.0 and up, the software endstops are adjusted to preserve the physical movement limits. Thus you could use G92 to set the middle of the bed to 0,0 and then run .gcode that was sliced for a Deltabot.


In earlier versions of Marlin G92 doesn’t update the software endstops, so it was unsupported to set coordinates outside these boundaries. In Marlin 1.1.0 and up, the physical boundaries are maintained. This means you can no longer use G92 to move below the bed, for example.


G92 [E<pos>] [X<pos>] [Y<pos>] [Z<pos>]

New extruder position


New X axis position


New Y axis position


New Z axis position


Specify that the nozzle’s current X position is 10 and the current extruder position is 90.

G92 X10 E90

Specify that the nozzle’s current XYZ position is 0, 0, 0.

G92 X0 Y0 Z0